Alfa GTV & 916 Spider - How To Program Keyless Entry (With & Without Code)

This guide will show you how to program your keyless entry for the following style keys:





TO DO THIS YOU DO NOT NEED THE BROWN MASTER KEY (that is only needed for imobiliser/alarm settings)


What you need to continue:

- A working circuit board that goes in your key as in picture at the bottom.
- A sharp small pin
- 4 digit keyless entry code. (NOT 5 DIGITS, NOT 16, BUT 4)

Step 1:

Behind the rear-view mirror you will see 2 small holes (see picture below)



Press the left button for 2 seconds (it will blink twice) by pushing a pin into it (see picture below). 




Step 2:

After the first 2 blinks in step 1 it will blink a third time, this indicates that it wants the first digit of the 4 digit code.

Say your 4 digit number is 4,0,1,2 for example

as soon as it blinks the third time press the pin into the hole 4 times (as that is the first digit) it will blink everytime you press it indicating a press. once that is done after about 2 seconds it will blink again on its own, this means it want the next number……just continue the rest of the numbers if its a 2 press it twice, wait for the blink then next number etc.

(if one of our numbers is 0, then don't press anything, after 2 seconds it will recognise this and blink asking for the next number…

once you are done it will begin to blink if the code is correct 10 times Go to STEP 3 --->

if your code is wrong it will be a solid light….(no blink) Wait until it turn of and repeat step 1.


Step 3:

Ok, So you have just put in the last number and the light is blinking while it's blinking press the pin in and hold it there, and now press the key button and hold it pressed for 10 seconds. 

Pull the pin out after 10 seconds and now release your finger from the key.

TA-DA! your done! That's it! 


If this did not work don't stress, go back and try it again.